FINAL DRIVE CASE BUSHING REPLACEMENT 125/125C THMS

MODELS AFFECTED: ALL THM 125/125-C TRANSAXLES

When servicing any THM 125/125-C transaxle that necessitates the replacement of the final drive assembly, inspect the case bushing for signs of wear or scoring.

Whenever the case bushing shows signs of wear or scoring, it must be replaced. Follow the service procedure given below:

SERVICE PROCEDURE

1. The transmission must be disassembled.

2. Remove the right axle seal assembly from the transmission case.

3. Following guidelines given in your service manual, remove the worn bushing and replace it with a new bushing (Part No. 8631119).

4. Inspect the case and bushing for burrs and loose aluminum. Remove all loose material.

5. Install a new right hand axle seal assembly (Part No. 8643%2).

6. Reassemble the entire transaxle following guidelines given in your service manual.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.