QUARTER WINDOW MODULE BRIGHT MOLDING REPLACEMENT
Bright metal reveal moldings for the "N" coupe quarter window module are available for service without replacing the entire quarter window module. The reveal moldings and clips are listed in group 12.113 in the CANSPO catalog as: strip, finish exterior quarter window. The following procedure should be used whenever it is necessary to replace this strip on a 1986-1988 "N"car coupe quarter window module.
-------- 1. Remove roof drip molding.
2. Using a small screwdriver, open the molding insert plate retaining tabs and remove the insert plate from the molding frame and the molding. Figure 1 view E.
3. Grasp the free (top) end of the bright molding and carefully remove it from the quarter window frame module at the clip locations. Figure 1 view A. Use of a long narrow screwdriver slipped in under the molding will help disengage the clips.
------------- 1. Install the required number of clips into the new molding.
2. Slide the lower end of the molding into the slot in the lower front corner of the molding frame and install the molding and clips in the molding frame. Figure 1 view A.
3. Install insert plate in molding and molding frame and bend tabs to retain.
4. Install roof drip molding.
Use the most applicable labour operation from the Canadian Labour Time Guide and claim 0.3 hours.
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.