GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 1998 🢒 Skylark 🢒 Engine 🢒 Engine Controls - 3.1L 🢒 Vehicle Speed Sensor Replacement

Removal Procedure
  1. Raise the vehicle. Support the vehicle. Refer to General Vehicle Lifting and Jacking in General Information.

    2. Object Number: 97328 Size: SH
  2. Disconnect the speed sensor electrical connector.

    3. Object Number: 97329 Size: SH
  3. Remove the speed sensor bolt.

    4. Object Number: 97330 Size: SH
  4. Remove the vehicle speed sensor from the case extension.
  5. Remove the O-ring from vehicle speed sensor.

Installation Procedure

    Object Number: 97330 Size: SH
  1. Install the O-ring onto the vehicle speed sensor.
  2. Install the vehicle speed sensor into the case extension.

    3. Object Number: 97329 Size: SH
  3. Install the speed sensor bolt.

    4. Tighten
    Tighten the bolt to 11 N·m (97 lb in).

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.


    Object Number: 97328 Size: SH
  4. Connect the electrical connector.
  5. Lower the vehicle.