Caution: Do not strike or jolt the inflatable restraint side impact sensor (SIS). Before applying power to the SIS make sure that it is securely fastened. Failure to observe the correct installation procedures could cause SIR deployment, personal injury, or unnecessary SIR system repairs.

Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedures

1. Disable the supplemental Inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
2. Remove the center pillar lower trim. Refer to Center Pillar Lower Trim Panel Replacement in Interior Trim.

1

Connector, Side Impact Sensor Electrical

Tip
Remove the connector position assurance (CPA) from the yellow harness connector.

2

Bolts, Inflatable Restraint Side Impact Sensor (Qty: 2)

Tip
Loosen the bolts only.

Tighten
10 N·m (89 lb in)

3

Sensor, Inflatable Restraint Side Impact