Some 1990-1/2 Allantes may experience a condition where the seat belt may not completely retract into the seat belt retractor. This may result in damage to the door trim panel or the seat when closing the door. A seat belt retractor stop button is available through CANSPO (refer to the chart below for the appropriate colour P/N) and can be installed on the shoulder belt to allow the seat belt to retract completely.
Belt Retractor Male Button Female Button Button Colour P/N P/N ------------- ----------- ------------ Light Beige 3529441 3529445 Garnet Red 3529442 3529446 Black 3529443 3529447
To install the seat belt retractor stop button use the following procedure:
1. Install the male half of the belt retractor button on the shoulder belt 762mm (30") from the end of webbing. Refer to Figure 1. Be sure that button is centered on the width of the webbing.
2. Place the female half of the button on the snap ball and snap the button together with channel lock pliers.
3. Using a sharp instrument, such as a knife or needle-nose pliers, dull the tip of the male button half as shown in Figure 2.
4. Repeat procedure on opposite shoulder belt.
Use the most applicable Labour Operation and Time from the Canadian Labour Time Guide.
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.