Starter Replacement LP1, LY7

1. Turn the ignition OFF.
2. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .



4. Disconnect the starter solenoid electrical connector from the starter.



5. Remove the starter terminal nut (1) and the battery positive cable (2) from the starter.



6. Remove the starter motor bolts.
7. Remove the starter motor.

1. Install the starter motor.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the starter motor bolts.

Tighten
Tighten the bolts to 50 N·m (37 lb ft).




3. Install the battery positive cable (2) to the starter and install the starter terminal nut (1).

Tighten
Tighten the nut to 13 N·m (115 lb in).




4. Connect the electrical connector to the starter solenoid.
5. Lower the vehicle.

Starter Replacement LS6

Caution: Refer to Battery Disconnect Caution in the Preface section.




1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
2. Remove the right side catalytic converter. Refer to Catalytic Converter Replacement - Right Side in Engine Exhaust.
3. Remove the inboard exhaust manifold to catalytic converter stud.
4. Remove the positive battery cable nut.
5. Remove the positive battery cable terminal and the engine harness leads from the solenoid.
6. Remove the positive assurance pin and disconnect the wire lead from the starter solenoid.



7. Support the starter motor.
8. Remove the starter motor bolts.
9. Remove the starter motor.

Notice: Refer to Fastener Notice in the Preface section.




1. Position the starter motor to the block.
2. Install the starter motor bolts.

Tighten
Tighten the bolts to 50 N·m (37 lb ft).




3. Install the wire and positive assurance pin to the starter solenoid.
4. Install the battery positive cable to the starter terminal.
5. Install the battery positive cable to starter terminal nut.

Tighten
Tighten the nut to 10 N·m (89 lb in).

6. Install the inboard exhaust manifold to catalytic converter stud.

Tighten
Tighten the exhaust manifold stud to 25 N·m (18 lb ft).

7. Install the right side catalytic converter. Refer to Catalytic Converter Replacement - Right Side in Engine Exhaust.
8. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .