Schematic Reference: Navigation System Schematics

DEFINITION: When playing a video input source connected to the auxiliary RCA video jacks, the video is inoperative or degraded.

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

1. Turn ON the ignition with the engine OFF. The Cadillac emblem screen appears on the navigation radio.
2. Leave the vehicle in PARK.
3. Press the MAIN MENU button on the radio. The main menu appears on the display.
4. Press the TV button on the main menu screen.
5. Select a TV station. The TV should be clear on the radio display.
6. Connect a VCR to the auxiliary RCA video jacks.
7. Select AUX VIDEO under the TV SETUP menu.
8. Observe the display. The VCR selection should appear on the radio. The picture and audio should be clear.

Does the system operate normally?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

Test the operation of the TV in the navigation radio.

Does the TV operate correctly?

Go to Step 4

Go to Symptoms - Navigation Systems

Test the auxiliary ground circuit for an open, a short to ground or a short to voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 11

Go to Step 5

Test the auxiliary video high signal circuit for an open, a short to ground or a short to voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 11

Go to Step 6

Test for a short between the auxiliary video high signal circuit to the auxiliary ground circuit. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 11

Go to Step 7

Inspect for poor connections at the harness connector of the auxiliary RCA video jacks. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 11

Go to Step 8

Replace the auxiliary RCA video jacks. Refer to Auxiliary Audio/Video Input Control Replacement .

Did you find and correct the condition?

Go to Step 11

Go to Step 9

Inspect for poor connections at the harness connector of the TV antenna module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 11

Go to Step 10

Replace the TV antenna module. Refer to Control Module References in Computer/Integrating Systems.

Did you complete the replacement?

Go to Step 11

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3