For 1990-2009 cars only
Removal Procedure
- Starting at either the windshield pillar or the rear glass, carefully pull off the finish molding from the roof ditch.
- Remove the roof panel joint finish molding.
- Clean excessive tape residue from the roof ditch with a 50/50 mixture by volume of isopropyl alcohol and water.
- Wipe dry the roof ditch with a clean lint-free cloth.
Important: If the roof panel finish molding cracks, breaks, or is damaged in any way, replace the molding.
Installation Procedure
- Ensure the body and part temperature is above 19°C (66°F).
- Peel approximately 3 inches of the tape backing from the finish molding.
- Align the finish molding to the roof header at the windshield opening.
- Begin at the front of the vehicle, position the molding into the roof ditch.
- Working rearward, remove the tape backing while pressing the finish molding into the roof ditch.
- Secure the finish molding from front to rear in the roof ditch.
Important: The body and component part temperature must be above 19°C (66°F) prior to adhesion.
