Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Driver Seat Schematics or Passenger Seat Schematics Connector End View Reference: Power Seat Connector End Views DEFINITION: The driver or passenger seat stays warm. | |||
1 | Did you review the heated seat operation and perform the necessary inspection? | Go to Step 2 | Go to Symptoms - Seats |
2 | Verify that the Heated Seat Always On complaint is present. Does the heated seat system operate as described in the system description and operation? | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 |
Does the Heated Seat Switch parameter display Pressed? | Go to Step 7 | Go to Step 4 |
4 | Test the heated seat control module high/low signal circuit between the rear integration module and the heated seat module for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 10 | Go to Step 5 |
5 | Test the heated seat control module status signal circuit between the rear integration module and the heated seat module for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 10 | Go to Step 6 |
6 | Inspect for poor connections at the harness connector of the heated seat module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 10 | Go to Step 8 |
7 | Inspect for poor connections at the harness connector of the HVAC control module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 10 | Go to Step 9 |
8 | Replace the heated seat module. Refer to Control Module References in Computer/Integrating Systems for replacement, setup and programming. Did you complete replacement? | Go to Step 10 | -- |
9 | Replace the HVAC control module. Refer to Control Module References in Computer/Integrating Systems for replacement, setup and programming. Did you complete the replacement? | Go to Step 10 | -- |
10 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 2 |
