Tools Required

1. Place the transmission in neutral.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
3. Remove the propeller shaft (6). Refer to Propeller Shaft Replacement .



4. Install the J 45012 to the drive flange.
5. While holding the J 45012 , remove the flange nut using the J 29873 .
6. Remove the J 45012 .



7. Remove the drive flange thrust washer.
8. Remove the drive flange using the J 45019 .



9. Use the J 6125-1B and J 23129 to remove the transmission case extension seal (1).

Important: Install the seal onto the tool before installing into the case to prevent damage to the seal.

1. Using J 44765 install the new transmission case extension seal (1).



2. Install the drive flange to the transmission output shaft.
3. Install a NEW drive flange thrust washer.



4. Install the J 45012 to the drive flange.

Notice: Refer to Fastener Notice in the Preface section.

5. While holding J 45012 , install a NEW drive flange nut using J 29873 .

Tighten
Tighten the drive flange nut to 57 N·m (42 lb ft).

6. Remove the J 45012 from the drive flange.



7. Install the propeller shaft (6). Refer to Propeller Shaft Replacement .
8. Lower the vehicle.