For 1990-2009 cars only
Removal Procedure
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle i.
- Disconnect the heated oxygen sensor (HO2S) electrical connector. Note the harness routing and retainers for reassembly.
- Remove the HO2S (1).
Notice: Refer to Heated Oxygen and Oxygen Sensor Notice in the Preface section.
Notice: Refer to Excessive Force and Oxygen Sensor Notice in the Preface section.
Installation Procedure
- Coat the threads of the HO2S with the anti-seize compound P/N 5613695, or the equivalent if necessary.
- Install the HO2S (1).
- Connect the HO2S electrical connector. Ensure that the harness is routed and retained as noted during disassembly.
- Lower the vehicle.
Important: Use special anti-seize compound on the HO2S threads. The compound consists of graphite suspended in fluid and glass beads. The graphite burns away, but the glass beads remain, making the sensor easier to remove. New or service sensors already have the compound applied to the threads. If you remove an oxygen sensor and if for any reason you must reinstall the same oxygen sensor, apply the anti-seize compound to the threads before reinstallation.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the HO2S to 41 N·m (30 lb ft).
