Removal Procedure
Important: Do not swap digital radio receivers between vehicles. Swapping digital receivers between vehicles will activate the digital radio Theftlock, "XM Theftlock" will be displayed.
- Remove the rear self panel. Refer to
Rear Window Shelf Trim Panel Replacement.
- Disconnect the electrical connectors on the receiver.
- Remove the fasteners securing the receiver to the rear shelf carrier.
- Remove the receiver.
Installation Procedure
- Install the receiver to the rear carrier.
Notice: Refer to Fastener Notice in the Preface section.
- Install the fasteners securing the receiver to the rear carrier.
Tighten
Tighten the fasteners to 2 N·m (17 lb in).
- Connect the electrical connectors.
- Install the rear self panel. Refer to
Rear Window Shelf Trim Panel Replacement.
- Perform the setup procedure for the digital radio receiver. Refer to
Control Module References for programming and setup information.