Removal Procedure
- Remove the transmission support. Refer to
Transmission Support Replacement
.
- Lower the rear of the transmission.
- Disconnect the vehicle speed sensor (VSS) electrical connector.
- Remove the VSS bolt (215).
- Remove the VSS (213) from the rear extension housing.
Installation Procedure
- Install the VSS (213) to the rear extension housing.
Notice: Refer to Fastener Notice in the Preface section.
- Install the VSS bolt (215).
Tighten
Tighten the bolt to 8 N·m (71 lb in).
- Connect the VSS electrical connector.
- Raise the rear of the transmission.
- Install the transmission support. Refer to
Transmission Support Replacement
.