For 1990-2009 cars only
Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
- Remove the shock module from the vehicle. Refer to Shock Absorber and Spring Assembly Replacement .
- Install the shock module into the spring compressor.
- Mark the upper control arm assembly and insulator for proper installation.
- Turn the spring compressor forcing screw (1) until the coil spring (2) is compressed.
- Remove the shock absorber upper retaining nut.
- Remove the shock absorber from the shock module.
- Loosen the compressor forcing screw until the upper mounting plate and coil spring may be removed.
- Remove the upper control arm bracket assembly, insulator and coil spring from the spring compressor.
Notice: Use care when handling the coil springs in order to avoid chipping or scratching the coating. Damage to the coating will result in premature failure of the coil springs.
Important: The spring is compressed when the shock absorber moves freely.
Installation Procedure
- Install the coil spring, insulator, upper control arm bracket assembly, and shock absorber to the spring compressor aligning all marks.
- Turn the spring compressor forcing screw (1) until the coil spring is compressed.
- Install the shock absorber retaining nut.
- Remove the shock module from the spring compressor.
- Install the shock module to the vehicle. Refer to Shock Absorber and Spring Assembly Replacement .
- Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
- Lower the vehicle.
Important: Ensure the alignment pins in the upper control arm bracket is orientated 90 degrees with the shock absorber lower mounting holes.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the nut to 25 N·m (18 lb ft).
