Preliminary Procedure

1. Open the rear compartment lid.
2. Remove the two rear license plate lamps. Refer to Rear License Lamp Replacement .
3. Remove the rear compartment lid interior trim. Refer to Rear Compartment Lid Inner Panel Trim Replacement .

1

Rear Compartment Lid Lower Trim Nut (Qty: 2)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
7 N·m (62 lb in)

2

License Plate Pocket Screw (Qty: 2)

Tighten
2.5 N·m (22 lb in)

3

Rear Compartment Lid Latch Pocket Screw (Qty: 2)

Tighten
2.5 N·m (22 lb in)

4

(W-clip) Retainer (Qty: 2)

Procedure

1. Release the retainers from inside the rear compartment lid.
2. Disengage the retainers by compressing the wings and pushing outward from the rear compartment lid.
3. Ensure the foam gaskets are in place prior to securing the (W-clip) retainers.
4. Close the rear compartment lid before applying pressure to the outer retainers.

5

Rear Lamp Electrical Connector

Tip
Disengage the electrical harness grommet from the rear compartment lid.

6

Rear Compartment Lid Lower Trim

Tip
Transfer the parts as needed.