Special Tools

For equivalent regional tools, refer to Special Tools.

Caution: Refer to Fastener Caution in the Preface section.





Note: 

•

If replacing the crankshaft balancer on manual transmission applications, note the location of any existing balance weights, if applicable. Crankshaft balance weights must be installed into the new balancer in the same location as the old balancer. A properly installed balance weight will be either flush or below flush with the face of the balancer. Refer to Engine Balancing.

•	Do not use the crankshaft balancer bolt again. Install a NEW crankshaft balancer bolt during final assembly.

1. Install the J 42386-A tool and bolts.

Use 1 M10 - 1.5 x 120 mm and 1 M10 - 1.5 x 45 mm bolt for proper tool operation and tighten the J 42386-A tool bolts to 50 N·m (37 lb ft).




2. Remove the crankshaft balancer bolt (139).



3. Use the J 41816-A remover  (1) and the J 41816-2 protector  (2) in order to remove the crankshaft balancer.



4. Remove the crankshaft balancer (1).



5. Remove the crankshaft balancer washer (1) from the balancer, as required.



6. Note the position of the crankshaft balance weights, if applicable for manual transmission applications. Refer to Engine Balancing and Crankshaft Balancer Cleaning and Inspection.