Front Wheel Speed Sensor Replacement AWD

Warning: Refer to Brake Dust Warning in the Preface section.




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
3. Disconnect the wheel speed sensor electrical connector (1).
4. Remove the wheel speed sensor wire harness clips (2) from the stabilizer bar bracket.



5. Remove the wheel speed sensor wire harness clip (1) from the steering knuckle.



6. Thoroughly clean the wheel speed sensor mounting area of the steering knuckle of any dirt and debris.
7. Remove the wheel speed sensor bolt (1).



8. Remove the wheel speed sensor (1) from the steering knuckle.

1. Install the wheel speed sensor (1) to the steering knuckle.

Caution: Refer to Fastener Caution in the Preface section.




2. Install the wheel speed sensor bolt (1) and tighten to 9 N·m (80 lb in).



3. Install the wheel speed sensor wire harness clip (1) to the steering knuckle.



4. Connect the wheel speed sensor electrical connector (1).
5. Install the wheel speed sensor wire harness clips (2) to the stabilizer bar bracket.
6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.

Front Wheel Speed Sensor Replacement RWD

Warning: Refer to Brake Dust Warning in the Preface section.




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
3. Disconnect the wheel speed sensor electrical connector (1).



4. Remove the wheel speed sensor wire harness clips (1) from the vehicle frame.



5. Remove the wheel speed sensor wire harness clip (1) from the steering knuckle.



6. Thoroughly clean the wheel speed sensor mounting area of the steering knuckle of any dirt and debris.
7. Remove the wheel speed sensor bolt (1).



8. Remove the wheel speed sensor (1) from the steering knuckle.

1. Install the wheel speed sensor (1) to the steering knuckle.

Caution: Refer to Fastener Caution in the Preface section.




2. Install the wheel speed sensor bolt (1) and tighten to 9 N·m (80 lb in).



3. Install the wheel speed sensor wire harness clip (1) to the steering knuckle.



4. Install the wheel speed sensor wire harness clips (1) to the vehicle frame.



5. Connect the wheel speed sensor electrical connector (1).
6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.