| Table 1: | Pedestrian Impact Detection Module Scan Tool Data Parameters |
| Table 2: | Pedestrian Impact Detection Module Scan Tool Output Controls |
Parameter | System State | Expected Value | Description |
|---|---|---|---|
Operating Conditions: Engine ON | |||
Battery Voltage Signal | -- | Varies | This displays volts. This is the current battery voltage signal. |
Discriminating Sensor | -- | Varies | The scan tool displays Equipped or Not Equipped. Equipped is displayed if the vehicle has a discriminating sensor. |
Discriminating Sensor | -- | Ready | The scan tool displays Ready or Not Ready. This is the state of the discriminating sensor. |
Discriminating Sensor Force | -- | Varies | This displays Counts. This is the discriminating sensor force measured in counts. |
Discriminating Sensor Temp. | -- | Varies | This displays °F (°C). This is the current discriminating sensor temperature. |
Left Hood Hinge Actuator | -- | Varies | The scan tool displays Equipped or Not Equipped. Equipped is displayed if the vehicle is displayed with a left hood hinge actuator. |
PID System Deployed Message | -- | Not Requested | The scan tool displays Requested or Not Requested. This is the state of the PID system deployed message. |
PIDS System Disabled Message | -- | Not Requested | The scan tool displays Requested or Not Requested. This is the state of the PID system deployed message. |
Power Mode | -- | Run | The scan tool displays Off, Accessory, Run or Crank Request. This is the state of the ignition switch. |
Right Hood Hinge Actuator | -- | Varies | The scan tool displays Equipped or Not Equipped. Equipped is displayed if the vehicle has a right hood hinge actuator. |
Safing Sensor | -- | Varies | The scan tool displays Equipped or Not Equipped. Equipped is displayed if the vehicle has a safing sensor. |
Safing Sensor Accelerometer | -- | 0 g | This displays g. |
Safing Sensor Status | -- | Ready | The scan tool displays Ready or Not Ready. This is the current status of the safing sensor. |
Service PID System Message | -- | Not Requested | The scan tool displays Requested or Not Requested. This is the state of the service PID system message. |
Vehicle Speed | -- | 0 km/h (0 mph) | This displays km/h (mph). This is the current vehicle speed. |
Voltage Status | -- | Normal | The scan tool displays Normal, Undervoltage or Overvoltage. This is the battery system status. |
Output Control | Description |
|---|---|
Data Recorder | This output control is used to enable or disable the diagnostic data recorder. |
Setup New PIDM | This output control is used to setup a new pedestrian impact detection module (PIDM). |
