GM Service Manual Online
For 1990-2009 cars only
Makes
🢒
Cadillac
🢒
2009
🢒
CTS
🢒
Suspension
🢒
Electronic Suspension Control
🢒 Electronic Suspension Front Position Sensor Replacement
Removal Procedure
Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle
.
Remove the tire and wheel. Refer to
Tire and Wheel Removal and Installation
.
Disconnect the front ride sensor link from the upper control arm ball stud.
Disconnect the front ride sensor harness connector.
Loosen the front ride sensor retaining nut.
Gently tap the front ride sensor retaining stud in order to loosen the stud to fender connection.
Remove the front ride sender from the vehicle.
Installation Procedure
Position the sensor to the vehicle.
Caution:
Refer to
Fastener Caution
in the Preface section.
Install the front ride sensor retaining nut and tighten to
9 N·m (80 lb in)
.
Connect the front ride sensor link to the upper control arm ball stud.
Connect the front ride sensor harness connector.
Install the tire and wheel. Refer to
Tire and Wheel Removal and Installation
.
Lower the vehicle.