Diagnostic Instructions

DTC Descriptors

DTC B3567 01: Driver Information Center Select Switch Circuit Short to Battery

DTC B3567 59: Driver Information Center Select Switch Circuit/Component Protection Time-Out

Diagnostic Fault Information

Circuit	Short to Ground	Open/High Resistance	Short to Voltage	Signal Performance
DIC Switch Signal	1	1	P3567	P3567
DIC Select Switch Signal	1	1	1	P3567
DIC Switch Low Reference	--	1	--	--
DIC Switch Ground	--	1	--	--
1. Driver Information Center (DIC) Switch Malfunction

Circuit/System Description

The driver information center (DIC) switch is a multiplexed switch. Battery power is provided to the DIC switch via the instrument panel cluster (IPC). The DIC switch signal circuit is pulled up to battery voltage in the IPC. The IPC also provides the DIC switch with a low reference. The switch input to the IPC is pulled low when a switch is activated. The DIC switch is a momentary contact switch that connects a series of resistors in a resistor ladder format. The IPC monitors the DIC switch signal circuit to determine the DIC switch inputs. Each switch state - Set/Reset, Trip/Fuel, Vehicle Information, Personalization, INFO UP, INFO DOWN - corresponds to a certain resistance value. The IPC determines the switch pressed by the voltage drop across the resistors.

Conditions for Running the DTC

The ignition is in ACCESSORY or RUN.

Conditions for Setting the DTC

B3567 59

The IPC detects that the DIC switch is stuck.

B3567 01

The IPC detects that the DIC switch signal circuit is shorted to battery.

Action Taken When the DTC Sets

The IPC ignores the DIC switch inputs.

Conditions for Clearing the DTC

Diagnostic Aids

Reference Information

Schematic Reference

Instrument Cluster Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Driver Information Center (DIC) Description and Operation

Electrical Information Reference

Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification

Ignition ON, verify that when the DIC switches are pressed and released the DIC scan tool parameters toggle between Active and Inactive.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the driver information center (DIC) switch.
2. Ignition OFF, test for less than 1 ohm between the low reference circuit terminal 2 and ground.

⇒	If greater than the specified range, test the low reference circuit for an open/high resistance.

3. Ignition OFF, test for less than 5 ohm between the ground circuit terminal 6 and ground.

⇒	If greater than the specified range, test the ground circuit for an open/high resistance.

4. Ignition ON, verify that all of the scan tool DIC Switch parameters are Inactive.

⇒	If any are not Inactive, test the signal circuits terminal 1 or terminal 3 for a short to ground. If the circuit tests normal, replace the IPC.

5. Ignition ON, install a 3A fused jumper wire between the signal circuit terminal 1 and the low reference circuit terminal 2. Verify the scan tool DIC Switch parameters, except the DIC Fuel Info. parameter are Active.

⇒	If any are not Active, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the IPC.

6. Ignition ON, install a 3A fused jumper wire between the signal circuit terminal 3 and ground. Verify the scan tool DIC Fuel Info. parameter is Active.

⇒	If not Active, test the signal circuit for a short to voltage or and open/high resistance. If the circuit tests normal, replace the IPC.

7. If all the circuits test normal, test or replace the DIC switch.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.