Special Tools

For equivalent regional tools, refer to Special Tools.

1. Remove the detent guide plate attaching bolts.
2. Remove the detent guide plate.

1. Remove the cooler line return fitting (1).
2. Remove the transmission case fill plug (2).
3. Remove the coolant temperature sensor (3).



4. Remove the backup lamp switch connector harness bolt (2).
5. Remove the backup lamp switch connector harness (1).
6. Remove the backup lamp switch (3).



7. Remove the dowel pins (1).




Note: Do not replace the bearing race unless inspection shows bearing race damage.

8. Remove the countershaft bearing race (3), using the J 8092 drive handle  (1) and the J 39790-A race remover  (2).




Note: Do not replace the bearing race unless inspection shows bearing race damage.

9. Remove the mainshaft bearing race (3), using the J 8092 drive handle  (1) and the J 39790-A race remover  (2).



10. Remove the Ist/2nd and the 3rd/4th shift shaft bearing (3), using the J 36190 driver handle  (1) and the J 44384 remover  (2).

1. Remove the vent assembly (1).
2. Remove the pump outlet cooler fitting with o-ring (2).
3. Remove the transmission fluid pump outlet pipe fitting (3).




Note: There may be one or more shims.

4. Remove the input shaft bearing race (1) and one or more shims (2).



5. Remove the countershaft bearing race (1) and one or more the shims (2).



6. Remove and discard the input shaft seal (1).



7. Remove the 1st/2nd shift shaft bearing, using the J 45124 removal bridge  (1) with the DT 49216 bushing remover  (2) and a wrench.



8. Remove the 3rd/4th shift shaft bushing, using the J 23907-1 slide hammer  (1) with the J 39439-2 bushing remover  (2).



9. Remove the dowel pins (1).



10. Remove the retainer ring (1).
11. Remove the oil pump cover assembly (2).
12. Remove the oil pump (3).



13. Remove the transmission fluid pump spring retaining plug (1).
14. Remove the transmission fluid pump spring (2).
15. Remove the transmission fluid pump check ball (3).