Special Tools

1. Place the transmission in neutral.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
3. Remove the propeller shaft (6). Refer to Rear Propeller Shaft Replacement.



4. Install the J 45012 to the drive flange.
5. While holding the J 45012 , remove the flange nut using the J 29873 .
6. Remove the J 45012 .



7. Remove the drive flange thrust washer.
8. Remove the drive flange using the J 45019 .



9. Use the J 6125-1B and J 23129 to remove the transmission case extension seal (1).

Note: Install the seal onto the tool before installing into the case to prevent damage to the seal.

1. Using J 44765 install the new transmission case extension seal (1).



2. Install the drive flange to the transmission output shaft.
3. Install a NEW drive flange thrust washer.



4. Install the J 45012 to the drive flange.

Caution: Refer to Fastener Caution in the Preface section.

5. While holding J 45012 , install a NEW drive flange nut using J 29873 .

Tighten the drive flange nut to 57 N·m (42 lb ft).

6. Remove the J 45012 from the drive flange.



7. Install the propeller shaft (6). Refer to Rear Propeller Shaft Replacement.
8. Lower the vehicle.