Draining Procedure
- Raise and suitably support the vehicle. Refer to
Lifting and Jacking the Vehicle.
- Clean away all dirt and debris from the transmission fluid temperature sensor/drain plug area.
- Place a suitable drain pan under the transmission.
- Disconnect the electrical connector from the transmission fluid temperature sensor/drain plug.
- Remove the fluid temperature sensor/drain plug (4).
- Allow the system to drain.
Caution: Refer to Fastener Caution in the Preface section.
- Install the transmission fluid temperature sensor/drain plug (4) and tighten to
18 N·m (13 lb ft).
- Connect the electrical connector to the transmission fluid temperature sensor/drain plug.
Filling Procedure
- Clean away all dirt and debris from the transmission fluid fill plug area.
- Remove the transmission fluid fill plug.
- Fill the transmission with DEXRON®-III transmission fluid, until even with the bottom of the fill plug hole.
- Install the transmission fluid fill plug and tighten to
18 N·m (13 lb ft).
- Remove the drain pan.
- Lower the vehicle.