GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2009 🢒 CTS 🢒 Body Hardware and Trim 🢒 Interior Trim and Paneling 🢒 Rear Side Door Window Replacement

Removal Procedure

    Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

  1. Lower the window all the way down.
  2. Remove the door trim panel. Refer to Rear Side Door Trim Panel Replacement.
  3. Remove the water deflector.
  4. Remove the window inner belt sealing strip. Refer to Rear Side Door Window Inner Sealing Strip Replacement.
  5. Remove the rear side door stationary window. Refer to Rear Side Door Stationary Window Replacement.
  6. Remove the window outer belt sealing strip. Refer to Rear Side Door Window Outer Sealing Strip Replacement.
  7. Connect the door trim panel electrical connector.
  8. Run the window to the full up position.
  9. Tape the window in the up position.

    10. Object Number: 758774 Size: SH
  10. Loosen the window clamp nuts 4 revolutions.
  11. Using the power window switch, lower the window regulator to the full down position.
  12. Remove the tape.
  13. Slide the window down past the window regulator clamps and out of the front window run channel.
  14. Lift the window out of the door.

Installation Procedure

    Object Number: 758774 Size: SH
  1. Install the window down into the door assembly, inboard of the rear door stationary post, past the window clamps.
  2. Position the glass into the stationary window post channel.
  3. Raise the window past the window clamps.
  4. Lower the window into the window clamps.

    5. Caution: Refer to Fastener Caution in the Preface section.

  5. Install the stationary window post bolt and tighten to 9 N·m (80 lb in).
  6. Push the glass forward into the front glass run channel.

    7. Note: Start the vehicle in order to ensure maximum power to the window motor. This is required to fully seat the window for adjustment.

  7. Start the vehicle.
  8. Using the power window switch, raise the window to the full up position. Tighten the window clamp nuts to 11 N·m (98 lb in).
  9. Inspect the window for proper operation and a tight seal.
  10. Shut off the vehicle.
  11. Install the rear side door stationary window. Refer to Rear Side Door Stationary Window Replacement.
  12. Install the window outer belt sealing strip. Refer to Rear Side Door Window Outer Sealing Strip Replacement.
  13. Install the window inner belt sealing strip. Refer to Rear Side Door Window Inner Sealing Strip Replacement.
  14. Install water deflector.
  15. Install the door trim panel. Refer to Rear Side Door Trim Panel Replacement.