Warning: Refer to Protective Goggles and Glove Warning in the Preface section.

Warning: Refer to Exhaust Service Warning in the Preface section.

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.



2. Apply a non petroleum based lubricant to the insulators and the hanger rods for ease of removal and installation.
3. Remove the muffler insulators (2) from the hanger mounting bracket rods (1).



4. Remove the nuts securing the rear energy absorber and the exhaust hanger mounting bracket (2) to the rear compartment rail.
5. Remove the stud plate (1) from the rear energy absorber.
6. Remove the exhaust hanger mounting bracket from the rear energy absorber.

1. Position the exhaust hanger mounting bracket (2) between the rear energy absorber and the stud plate (1).

Caution: Refer to Fastener Caution in the Preface section.

2. Install the bumper nuts securing the rear energy absorber and the hanger mounting bracket (2) to the rear compartment rail and Tighten to 25 N·m (18 lb ft).



3. Install the tail pipe insulators (2) to the hanger mounting bracket rods (1).
4. Lower the vehicle.