Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC B1271 00: Theft LockedCircuit/System Description
This DTC is generated by the module when the Theft Lock is activated. This occurs when the VIN as received over the data communication circuit and the VIN as stored in the module memory do not match. This also occurs when no VIN is received over the data communication circuit. The only circuit required is the communication line.
Conditions for Running the DTC
This DTC test runs when the radio changes from OFF to ON.
Conditions for Setting the DTC
This DTC is generated by the module when the VIN as received over the data communication circuit and the VIN as stored in the module memory do not match. This also occurs if no VIN is received over the data communication circuit.
Action Taken When the DTC Sets
The radio does not function. The radio will display indicate that Theftlock is active.
Conditions for Clearing the DTC
Re-calibration with the correct calibrations for the vehicle and cycling the radio to OFF then to ON will clear the DTC if there is no damage to the radio.
Reference Information
Schematic Reference
Radio/Navigation System Schematics
Connector End View Reference
Description and Operation
Radio/Audio System Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
Preform the appropriate radio programming or setup as directed in Control Module References.
| ⇒ | If the DTC resets, replace the radio.. |
Repair Instructions
Perform the Diagnostic Repair Verificationafter completing the diagnostic procedure.
Control Module References for radio replacement, setup, and programming.
