Tools Required

J 42067 Rear Main Oil Sealer Installer

1. Remove the engine flywheel from the crankshaft. Refer to Engine Flywheel Replacement .



2. Center punch the steel ring of the rear main oil seal.
3. Carefully drill a small, shallow, pilot hole into the steel ring of the rear main oil seal.
4. Screw in a self-tapping screw.
5. Use pliers to pull the rear main oil seal out.
6. Clean all sealing surfaces.

1. Coat the lip of the rear main oil seal with clean engine oil.



2. Use the J 42067 to install the rear main oil seal.
3. Clean the rear crankshaft flange.
4. Install the engine flywheel to the crankshaft. Refer to Engine Flywheel Replacement .