GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2003 🢒 CTS - RHD 🢒 Suspension 🢒 Suspension General Diagnosis 🢒 Stabilizer Shaft Link Replacement

Removal Procedure

    Notice: The ball stud must not rotate during disassembly or reassembly. Hand tools must be used to keep the ball stud from rotating. If air tools are used and the stud is allowed to rotate, damage to the ball stud and/or stud mounting hole may occur.

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .

    3. Object Number: 746681 Size: SH
  3. Disconnect the ABS sensor wiring harness from the stabilizer shaft link.

    4. Object Number: 750841 Size: SH
  4. Remove the stabilizer shaft link retaining nuts.
  5. Remove the stabilizer shaft link.

Installation Procedure

    Object Number: 750841 Size: SH

    Important: Apply threadlocker 242 or equivalent to the threads of the stabilizer shaft link.

  1. Install the stabilizer shaft link.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the stabilizer shaft link retaining nuts.

    3. Tighten
    Tighten the nuts to 50 N·m (37 lb ft).


    Object Number: 746681 Size: SH
  3. Connect the ABS sensor wiring harness to the stabilizer shaft link.
  4. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  5. Lower the vehicle.