Tools Required

1. Install the housing support bushing, if necessary. Refer to Differential Housing Support Bushing Replacement .
2. Support the housing in a press in the axle seal area.
3. Using the J 24433  (2) and the J 45010  (1) install the shim (4) and the race (3) into the differential housing.



4. Lightly lube the outer diameter of the seal with axle lube.
5. Using the J 44809 install the axle oil seal into the housing.



6. Install the selected shims or marked shims (2) on the pinion housing assembly (1) and the O-ring (3).
7. Apply a light coat of oil to the pinion housing assembly (1) and the O-ring (3).



8. Use the bolts from J 45019 .
9. Align the cage bolts to the carrier bolt holes.
10. Heat carrier with J 25070 and push the cage into place.

Notice: Refer to Fastener Notice in the Preface section.




11. Install the 6 pinion assembly bolts.

Tighten
Tighten the 6 pinion assembly bolts in a criss-cross pattern to 25 N·m (18 lb ft).




12. Install the differential carrier (2) into the housing (1).



13. Lightly lube the outer diameter of the seal with axle lube.
14. Using the J 44809 , install the axle oil seal into the differential side cover.



15. Install the housing cover O-ring (2) into the groove on the housing cover (3).
16. Apply a light coat of oil to the housing cover O-ring (2), install the housing cover (3) onto the housing (1).
17. Install the 9 side cover bolts (4).

Tighten
Tighten the 9 side cover bolts in a criss-cross pattern to 25 N·m (18 lb ft).

18. Install the drain plug and fill the axle with axle lube. Refer to Lubricant Change .