Backup Lamp Switch Replacement for Cadillac CTS - RHD 2003

Notice: When removing or installing the backup lamp switch, do not use an open end wrench. Use only a socket in order to avoid damage to the switch assembly.

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.



2. Disconnect the backup lamp switch electrical connector (2) from the backup lamp switch (1).



3. Remove the backup lamp switch assembly.

Notice: When removing or installing the backup lamp switch, do not use an open end wrench. Use only a socket in order to avoid damage to the switch assembly.

Notice: Refer to Component Fastener Tightening Notice in the Preface section.




1. Install the backup lamp switch.

Tighten
Tighten the switch to 18 N·m (13 lb ft).




2. Connect the backup lamp switch electrical connector (2) to the backup lamp switch (1).
3. Lower the vehicle.