Headlamp Washer Nozzle Replacement CE4 w/TT6

1. Remove the front bumper fascia (3). Refer to Front Bumper Fascia Replacement .



2. Depress the tab (2) on the headlamp washer hose connection, in order to disconnect the headlamp washer hose (1).
3. Disconnect the hose from the retainer on the headlamp.
4. Remove the 2 screws (4) from the washer nozzle bracket.



5. Remove the headlamp washer nozzle assembly (2) from the headlamp housing.

1. Install the headlamp washer nozzle assembly (2) to the headlamp housing.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the 2 screws (4) that retain the headlamp washer nozzle (2) to the headlamp housing.

Tighten
Tighten the screws (4) to 1.5 N·m (13 lb in).




3. Connect the headlamp washer hose.

Engage the male end of the headlamp washer hose (1) into the female of the end of the headlamp washer hose (2) with a firm push.

4. Secure the hose to the retainer on the headlamp.



5. Install the front bumper fascia (3). Refer to Front Bumper Fascia Replacement .