Removal Procedure
- Remove the door trim panel. Refer to Rear Side Door Trim Panel Replacement .
- Remove the water deflector. Refer to Rear Side Door Water Deflector Replacement .
- Partially open the window, if possible.
- Remove the window regulator. Refer to Rear Side Door Window Regulator Replacement .
- Remove the screws securing the power window motor to the window regulator.
- Twist the power window motor clockwise to remove the motor from the regulator.
Important: There is a binding effect on the power window motor drive when the window is in the fully closed or open position.
Installation Procedure
- Install the power window motor to the window regulator.
- Twist the power window motor counterclockwise to align the screw holes.
- Install the power window motor to regulator screws.
- Install the window regulator. Refer to Rear Side Door Window Regulator Replacement .
- Install the water deflector. Refer to Rear Side Door Water Deflector Replacement .
- Install the door trim panel. Refer to Rear Side Door Trim Panel Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the power window motor screws to 4 N·m (35 lb in).
