Removal Procedure
Caution: In order to reduce the risk of fire and personal injury observe the
following items:
• Replace all nylon fuel pipes that are nicked, scratched or damaged
during installation, do not attempt to repair the sections of the nylon fuel
pipes • Do not hammer directly on the fuel harness body clips when installing
new fuel pipes. Damage to the nylon pipes may result in a fuel leak. • Always cover nylon vapor pipes with a wet towel before using a
torch near them. Also, never expose the vehicle to temperatures higher than
115°C (239°F) for more than one hour, or more than 90°C (194°F)
for any extended period. • Apply a few drops of clean engine oil to the male pipe ends before
connecting fuel pipe fittings. This will ensure proper reconnection and prevent
a possible fuel leak. (During normal operation, the O-rings located in the
female connector will swell and may prevent proper reconnection if not lubricated.)
- Relieve the fuel system pressure. Refer to Fuel Pressure Relief .
- Clean the fuel and evaporative emission (EVAP) pipe connections and areas surrounding the connections prior to disconnecting the connections in order to avoid possible contamination of the fuel and/or EVAP system.
- Disconnect the fuel feed pipe (1) quick connect fitting at the fuel rail. Refer to Metal Collar Quick Connect Fitting Service .
- Disconnect the EVAP line (2) quick connect fitting at the EVAP canister purge valve. Refer to Plastic Collar Quick Connect Fitting Service .
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Loosen the fuel/EVAP pipe retainer bolt (1).
- Disconnect the fuel feed rear pipe quick connect fitting (1) from the chassis fuel line. Refer to Plastic Collar Quick Connect Fitting Service .
- Disconnect the chassis EVAP line quick connect fitting (1) from the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
- Drill out the rivets (5) securing the retainer (2) to the underbody.
- Disconnect the retainers (3, 4 and 1) from the underbody.
- Remove the fuel/EVAP lines from the vehicle and place on a suitable work surface.
- Remove the EVAP line from the retainers.
Installation Procedure
- Install the EVAP line to the retainers.
- Position the fuel/EVAP lines to the vehicle underbody.
- Connect the retainers (3, 4 and 1) to the underbody.
- Install NEW rivets (5) securing the retainer (2) to the underbody
- Connect the chassis EVAP line quick connect fitting (1) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
- Connect the fuel feed rear pipe quick connect fitting (1) to the chassis fuel line. Refer to Plastic Collar Quick Connect Fitting Service .
- Position the retainer to the front of dash.
- Tighten the fuel/EVAP pipe retainer bolt (1).
- Lower the vehicle.
- Connect the EVAP line (2) quick connect fitting at the EVAP canister purge valve. Refer to Plastic Collar Quick Connect Fitting Service .
- Connect the fuel feed pipe (1) quick connect fitting at the fuel rail. Refer to Metal Collar Quick Connect Fitting Service .
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
- Perform the following procedure in order to inspect for leaks:
- Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the bolt to 6 N·m (53 lb in).
| 13.1. | Turn ON the ignition, with the engine OFF for 2 seconds. |
| 13.2. | Turn OFF the ignition for 10 seconds. |
| 13.3. | Turn ON the ignition, with the engine OFF. |
| 13.4. | Inspect for fuel leaks. |
