GM Service Manual Online
For 1990-2009 cars only

DTC Descriptor

DTC B2976 00: Driver Door Ajar Circuit

Diagnostic Fault Information

Important: Always perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

Circuit

Short to Ground

Open/High Resistance

Short to Voltage

Signal Performance

Driver Door Ajar

B2976 00

1

1

--

1. Door Ajar Malfunction

Circuit/System Description

When the driver door lock is in to the AJAR position, ground is applied through the switch to the body control module (BCM). The BCM then sends a class 2 message to the instrument panel cluster to illuminate the ajar indicator.

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

The BCM receives a voltage signal on the driver door ajar circuit.

Action Taken When the DTC Sets

The Ajar indicator is ON at all times.

Conditions for Clearing the DTC

The BCM clears this code from current when the fault is removed from the system.

Reference Information

Schematic Reference

Door Lock/Indicator Schematics

Connector End View Reference

Power Door Systems Connector End Views

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs

Scan Tool Reference

    •  Scan Tool Output Controls
    •  Scan Tool Data List
    •  Scan Tool Data Definitions

Circuit/System Verification

Ignition ON, open the driver side door. The driver door ajar indicator should illuminate. Close the driver door. The ajar indicator should turn OFF.

Circuit/System Testing

  1. Disconnect the driver door lock connector. Verify the DTC resets.
  2. If the DTC does not reset, replace the driver door lock assembly.
  3. Test for a short to ground in the driver door ajar circuit.
  4. If all circuits/connections test normal, replace the BCM.

Repair Instructions

Important: Always perform the Diagnostic Repair Verification after completing the diagnostic procedure.

    •  Front Side Door Lock Replacement
    •  Front Side Door Inside Handle Replacement
    •  Rear Side Door Inside Handle Replacement
    •  Control Module References for BCM replacement, setup, and programming