Caution: When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling and Enabling . Failure to observe the correct procedure could cause deployment of the SIR components, personal injury, or unnecessary SIR system repairs.

Caution: Do not strike or jolt the inflatable restraint side impact sensor (SIS). Before applying power to the SIS make sure that it is securely fastened. Failure to observe the correct installation procedures could cause SIR deployment, personal injury, or unnecessary SIR system repairs.

Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedure

1. Disable the SIR. Refer to SIR Disabling and Enabling or SIR Disabling and Enabling .
2. Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement .

1

Inflatable Restraint Side Impact Sensor Assembly Bolt (Qty: 2)

Tip
Loosen the bolts and slide the sensor out of the key hole slots.

Tighten
9 N·m (80 lb in)

2

Inflatable Restraint Side Impact Sensor Assembly