Tools Required

1. Release the outer water pump drive belt tensioner and remove the drive belt from the drive pulley. Refer to Water Pump Belt Replacement .
2. Remove the end cap from the intake camshaft.



3. Remove the water pump drive pulley from the intake camshaft using the J 38825 .

1. Place the water pump drive pulley in position on the intake camshaft.



2. Install the water pump pulley onto the intake camshaft using the J 38823 . During installation, the tool will bottom out on the camshaft at the proper depth.

Notice: Refer to Fastener Notice in the Preface section.




3. Install the camshaft end cap.

Tighten
Tighten the cap to 2 N·m (18 lb in).

4. Install the water pump drive belt. Refer to Water Pump Belt Replacement .