GM Service Manual Online
For 1990-2009 cars only

    Object Number: 1564214  Size: SH
  1. If installing a NEW starter transfer the cables from the old starter.
  2. Install the positive battery cable to the starter motor stud.
  3. Notice: Refer to Fastener Notice in the Preface section.

  4. Install the starter motor stud nut (1).
  5. Tighten
    Tighten the starter motor stud nut (1) to 9.5 N·m (84 lb in).

  6. Install the solenoid wiring harness to the starter solenoid stud.
  7. Install the starter solenoid stud nut (2).
  8. Tighten
    Tighten the starter solenoid stud nut (2) to 3.4 N·m (30 lb in).


    Object Number: 1564133  Size: SH
  9. Place the starter motor in position in the engine valley.

  10. Object Number: 1564132  Size: SH
  11. Install the two starter motor bolts.
  12. Tighten
    Tighten the starter motor bolts to 30 N·m (22 lb ft).


    Object Number: 1564128  Size: SH
  13. Install a NEW O-ring onto the camshaft position (CMP) sensor.
  14. Lubricate the O-ring with clean engine oil.

  15. Object Number: 1564127  Size: SH
  16. Install the CMP sensor.
  17. Install the CMP sensor bolt.
  18. Tighten
    Tighten the CMP sensor bolt to 10 N·m (89 lb in).


    Object Number: 1564126  Size: SH
  19. Install a NEW O-ring onto the crankshaft position (CKP) sensor.
  20. Lubricate the O-ring with clean engine oil.

  21. Object Number: 1564124  Size: SH
  22. Install the CKP sensor.
  23. Install the CKP sensor bolt.
  24. Tighten
    Tighten the CKP sensor bolt to 10 N·m (89 lb in).


    Object Number: 1564122  Size: SH
  25. Install the knock (KS) sensors.
  26. Tighten
    Tighten the KS sensors to 20 N·m (15 lb ft).


    Object Number: 1564121  Size: SH
  27. Install the crankshaft position sensor wiring harness into the engine valley.

  28. Object Number: 1564119  Size: SH
  29. Connect the crankshaft position sensor wiring harness to the KS sensors (1).
  30. Connect the crankshaft position sensor wiring harness to the CKP sensor (2).

  31. Object Number: 1564118  Size: SH
  32. Connect the crankshaft position sensor wiring harness (1) to the CMP sensor.
  33. Install the jumping ground bracket bolt (2) to the right cylinder head.
  34. Tighten
    Tighten the jumping ground bracket bolt (2) to 20 N·m (15 lb ft).