GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2007 🢒 DTS 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Parking Brake Indicator Switch Replacement

Removal Procedure
  1. Remove the left closeout/insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
  2. Remove the left knee bolster. Refer to Driver Knee Bolster Replacement .
  3. Remove the left front carpet retainer. Refer to Front Carpet Retainer Replacement .

    4. Object Number: 107329 Size: SH
  4. Remove the park brake pedal assembly mounting nuts (1, 2).
  5. Position the park brake pedal assembly away from the mounting studs.

    6. Object Number: 153110 Size: SH
  6. Disconnect the electrical connector from the park brake warning lamp switch.
  7. Remove park brake warning lamp switch mounting bolt.
  8. Remove park brake warning lamp switch.

Installation Procedure

    Object Number: 153110 Size: SH
  1. Install the park brake warning lamp switch to the park brake lever assembly. Align the pin to the locator hole.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the park brake warning lamp switch mounting bolt.

    3. Tighten
    Tighten the park brake warning lamp switch mounting bolt to 2.0 N·m (18 lb in).


    Object Number: 107329 Size: SH
  3. Install the park brake pedal assembly to the mounting studs.
  4. Install the park brake pedal assembly mounting nuts (1, 2).

    5. Tighten
    Tighten the park brake pedal assembly mounting nuts to 24 N·m (18 lb ft).

  5. Connect the electrical connector to the park brake warning lamp switch.
  6. Install the left knee bolster. Refer to Driver Knee Bolster Replacement .
  7. Install the left closeout/insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
  8. Install the left carpet retainer. Refer to Front Carpet Retainer Replacement .