Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC C0558 4A: Calibration Data Not Programmed - Checksum errorCircuit/System Description
The electronic suspension control (ESC) module performs checks of internal calibration data. If a fault condition is detected, the ESC module will set the fault DTC, and may, depending upon the fault type, turn ON the SERVICE SUSPENSION SYSTEM message. Recovery from any controller fault condition is attempted only after the ignition is cycled ON and OFF.
Conditions for Running the DTC
Ignition ON.
Conditions for Setting the DTC
| • | The DTC is set when any calibration faults internal to the ESC module are detected. |
| • | The fault is detected during 3 consecutive ignition cycles, or during the same ignition cycle after clearing the DTC with the scan tool. |
Action Taken When the DTC Sets
| • | The ESC module disables all ESC functionality. |
| • | The ESC module sends a message to the instrument panel cluster (IPC) to display the SERVICE SUSPENSION SYSTEM message. |
Conditions for Clearing the DTC
A history DTC will clear when the ESC no longer senses the malfunction and the ignition is cycled ON and OFF.
Reference Information
Schematic Reference
Electronic Suspension Control Schematics
Connector End View Reference
Electronic Suspension Control Connector End Views
Description and Operation
Electronic Suspension Control Description and Operation
Electrical Information Reference
Scan Tool Reference
Circuit/System Verification
Verify that DTC C0558 is not set
| ⇒ | If the DTC, is set replace the ESC. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for ESC replacement, setup, and programming
