Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedures

1. Remove the wiper arms. Refer to Windshield Wiper Arm Replacement .
2. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
3. Remove the windshield frame reinforcement.
4. Disconnect the wiper transmission electrical connector from the main engine harness.
5. Push the wiper transmission electrical harness grommet into the plenum area.

1

Bolt, Windshield Wiper Motor

Tip

Tighten
9 N·m (80 lb in)

2

Bolt, Windshield Wiper Motor

Tighten
9 N·m (80 lb in)

3

Bolt, Windshield Wiper Motor

Tighten
9 N·m (80 lb in)

4

Module Assembly, Windshield Washer System

Tip
Raise the forward edge of the module assembly out of the plenum panel first followed by wiper motor.