Preliminary Procedures

1. Remove the driver knee bolster. Refer to Driver Knee Bolster Replacement .
2. Disconnect the electrical connector for the brake pedal position sensor.

1

Accelerator Pedal Assembly Nut (Qty: 2)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
10 N·m (89 lb in)

2

Accelerator Pedal

Tip
Position the accelerator pedal aside.

3

Brake Pedal Pushrod Retainer Clip

4

Spacer

5

Brake Pedal Assembly Nut (Qty: 4)

Procedure

Without disconnecting the intermediate shaft, lower the steering column to gain access to the nuts for the brake pedal mounting bracket. Refer to Steering Column Replacement .

Tighten

6

Brake Pedal

Procedure

After the installation is complete, calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration .