Removal Procedure
- Open the hood.
- Release the clip retaining the hood assist rod to the lower hood assist rod ball stud (1).
- Remove the lower hood assist rod ball stud (1) from the fender (2).
- Release the clip retaining the hood assist rod to the upper hood assist rod ball stud (2).
- Remove the upper hood assist rod ball stud (2) from the hood (1).
Caution: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.
Installation Procedure
- Install the upper hood assist rod ball stud (2) to the hood (1).
- Press the hood assist rod onto the upper hood assist rod ball stud (2).
- Ensure that the clip is fully seated on the hood assist rod.
- Install the lower hood assist rod ball stud (1) to the fender (2).
- Press the hood assist rod onto the lower hood assist rod ball stud (1).
- Ensure that the clip is fully seated on the hood assist rod.
- Close the hood.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the upper hood assist rod ball stud (2) to 9 N·m (80 lb in).
Tighten
Tighten the lower hood assist rod ball stud (1) to 24 N·m (18 lb ft).
