Tools Required

J 35917 Ball Joint Remover

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
3. Remove the brake rotor. Refer to Rear Brake Rotor Replacement .



4. Using the J 35917 , remove the wheel stud at the inner most notch in the knuckle on the caliper side of the steering knuckle.

1. Install the new wheel stud .
2. Using washers and a wheel nut, pull the wheel stud in position.
3. Install the brake rotor. Refer to Rear Brake Rotor Replacement .

Notice: Refer to Fastener Notice in the Preface section.

4. Install the brake caliper and bolts. Refer to Rear Brake Caliper Replacement .
5. Install the wheel and the tire. Refer to Tire and Wheel Removal and Installation .
6. Lower the vehicle.