Warning: The high intensity discharge system produces high voltage and current. In order to reduce the risk of severe shocks and burns, the battery negative cable must be disconnected any time service work is being performed on or around the high intensity discharge system.

Warning: The high intensity discharge system produces high voltage and current. To reduce the risk of severe shocks and burns:

Preliminary Procedure

1. Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement.
2. Remove the wheelhouse liner in order to access the rear headlamp assembly nut.

1

Headlamp Assembly Bolt (Qty: 3)

Caution: Refer to Fastener Caution in the Preface section.

Tip
Tighten the fasteners in sequence as shown.

Tighten
6 N·m (53 lb in)

2

Headlamp Assembly Nut

Tighten
6 N·m (53 lb in)

3

Headlamp Capsule Assembly

Tip
Pull outward on the housing in order to disconnect the electrical connection at the lower rear edge of the lamp.

4

Electrical Harness Connector

Tip
Disconnect the connector from the headlamp capsule assembly.