Coil Spring Replacement FE7

Special Tools

1. Raise the vehicle and support. Refer to Lifting and Jacking the Vehicle.
2. Remove the tires and the wheels. Refer to Tire and Wheel Removal and Installation.
3. Support the control arm with a suitable jack.
4. Remove the electronic level control air tube from the shock.
5. Remove the 2 bolts securing the shock to the control arm.



6. Remove the hex nut.
7. Using the J 24319-B



8. Install the J 44255 .
9. Slowly lower the control arm until it bottoms on the support assembly.
10. Remove the coil spring.

1. Install the coil spring in the J 44255 .



2. Install the spring ensuring the insulator is seated in the control arm.

Caution: Refer to Fastener Caution in the Preface section.




3. Raise the lower control arm and install the 2 shock bolts in the control arm.

Tighten
Tighten the shock bolts to 25 N·m (18 lb ft).




4. Install the adjustment link to the control arm.

Tighten
Tighten the adjustment link to 30 N·m (22 lb ft), then tighten an additional 180 degrees.

5. Connect the electronic level control air tube to the shock.
6. Install the tires and the wheels. Refer to Tire and Wheel Removal and Installation.

Tighten
Tighten the wheel nuts to 125 N·m (80 lb ft).

7. Lower the vehicle.
8. Check the toe and adjust if necessary. Refer to Rear Toe Adjustment.

Coil Spring Replacement FE1 and FE3

Special Tools

J 24319-B Steering Linkage Puller

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the tire and the wheel. Refer to Tire and Wheel Removal and Installation.
3. Support the lower control arm with a suitable jack.
4. Remove the automatic level control link from the lower control arm.
5. Remove the shock absorber lower retaining bolts.



6. Remove the adjustment link retaining nut.
7. Using J 24319-B



8. Slowly lower the lower control arm until it bottoms on the support assembly.
9. Remove the coil spring.

1. Install the coil spring ensuring the insulator is seated in the lower control arm.

Caution: Refer to Fastener Caution in the Preface section.




2. Raise the lower control arm and install the shock absorber lower retaining bolts.

Tighten
Tighten the shock absorber lower retaining bolts to 25 N·m (18 lb ft).




3. Install the adjustment link to the control arm.
4. Install the adjustment link retaining nut.

Tighten
Tighten the adjustment link retaining nut to 30 N·m (22 lb ft) then tighten an additional 180 degrees.

5. Connect the automatic level control link to the lower control arm.
6. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation.
7. Lower the vehicle.