Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedure

Remove the brake caliper mounting bracket. Refer to Rear Disc Brake Hardware Replacement .

1

Guide Pin

2

Guide Pin Boot

Tip

1. Install the bracket in a vise.
2. Insert a flat-bladed screwdriver between the boot and the bracket.
3. Using a flat-bladed screwdriver, remove the boot.

3

Guide Pin Bushing

Tip

Warning: Refer to Brake Dust Warning in the Preface section.

Caution: Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak.

Preliminary Procedures

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation.

1

Guide Pin Bolt (Qty: 2)

Caution: Refer to Fastener Caution in the Preface section.

Procedure

1. DO NOT use any air tools to remove or install the brake caliper guide pin bolts. Use hand tools ONLY.
2. Install an open end wrench to hold the caliper guide pin in line with the brake caliper while removing or installing the caliper guide pin bolts. DO NOT allow the open end wrench to contact the brake caliper. Allowing the open end wrench to contact the brake caliper will cause a pulsation when the brakes are applied.
3. Ensure the brake caliper guide pin seal is fully seated in the groove of the brake caliper guide pin and the guide pin slides freely in caliper bracket bore.

Tighten
34 N·m (25 lb ft)

2

Guide Pin (Qty: 2)

Procedure

Apply a small amount of high temperature silicone brake lubricate to the inside of the guide pin seal.

3

Guide Pin Seal