Preliminary Procedures

1. Remove the driver knee bolster. Refer to Driver Knee Bolster Replacement.
2. Remove the brake pedal position sensor. Refer to Brake Pedal Position Sensor Replacement.

1

Accelerator Pedal Assembly Nut (Qty: 2)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
10 N·m (89 lb in)

2

Accelerator Pedal

Tip
Position the accelerator pedal aside.

3

Brake Pedal Pushrod Retainer Clip

Procedure

1. Remove the brake pedal pushrod retainer clip bolt, if equipped.
2. After the installation is complete, rotate the brake pedal pushrod retainer clip to ensure the clip is fully engaged in the brake pedal clevis pin groove.

Tighten
7 N·m (62 lb in)

4

Spacer

5

Brake Pedal Assembly Nut (Qty: 4)

Procedure

Without disconnecting the intermediate shaft, lower the steering column to gain access to the nuts for the brake pedal mounting bracket. Refer to Steering Column Replacement.

Tighten

6

Brake Pedal

Procedure

After the installation is complete, calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration.