The front seat back cushions (left and/or right) on some 1985-87 Deville/Fletwoods may appear to tilt outward (toward the doors) by as much as 1/2" (12 mm) at the top of the seat. This condition can result if the seat back foam pad and cover are improperly installed on the seat back frame assembly.
To repair this condition, use the following procedure along with Section 9C of the appropriate Body Service Manual to reposition the pad and cover on the seat back frame.
1. Remove the effected front seat assembly (left or right side) from the vehicle. Place on a clean covered work bench and remove the head rest.
2. Remove the seat back from the seat assembly.
3. Remove the seat back cover. Loosen the foam pad from the seat back frame at the top and both sides.
4. Reposition the foam pad on the frame so that the top of the pad is 1/2" (12mm) inward toward the center of the vehicle as compared to the original position.
5. Secure the foam pad to the frame with new trim retaining clips (hog rings). Install the seat back cover.
6. Install the seat back onto the seat assembly. Install the head rest.
7. Install the seat assembly into the vehicle. Torque all four seat to floor attaching nuts to 24 ft. lbs. (32 N.m).
Use the most applicable labour operation from the Canadian Labour Time Guide and claim 1.4 hours per side.
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.