FENDER REPLACEMENT PROCEDURES INSTALL MODIFIED HOOD HINGE

SUBJECT: INFORMATION ON FENDER REPLACEMENT ON 1989-1991 DEVILLES AND FLEETWOODS

The 1991 DeVille and Fleetwood fender and hood hinges were modified at VIN M421807 to facilitate assembly of these parts and the front end metal in production. The current stock of service fenders at GMSPO reflects This change. Since there are no holes in the inner fender vertical wall, the old style hood hinge cannot be used during fender replacement on cars built from 1989 up to the 1991 VIN breakpoint. The new style hood hinge and a reinforcement bracket must be installed. For fender replacement use the following procedure:

1. Install modified hood hinge to side rail assembly.

2. Attach reinforcement mounting bracket to side rail with its tab against the hinge.

3. Install fender using procedure from Service Information Manual.

NOTE: The fender "L" bracket has a wing section that attaches onto the reinforcement mounting bracket. For more detail refer to Figure 1.

Listed for reference are the part numbers:

LH RH

Fender 25601113 25601114 Hood Hinge 25601111 25601112 Reinforcement Mounting Bracket 25601119 25601120

Parts are currently available from GMSPO.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.