POPPING NOISE IN FRONT DOOR (APPLY ADHESIVE)

VEHICLES AFFECTED: 1989 C

Some 1989 DeVilles and Fleetwoods may exhibit a popping noise and/or clicking noise when the front door glass is raised to within 6-1/2" from fully closed. This condition may be caused by loose rivets in the window sash channel.

To repair this condition use the following procedure:

1. Remove door trim panel.

2. Working through access hole in door inner panel, trim rubber between glass and lower sash channel flush with upper surface of sash channel.

3. Apply either 3M Channel Bond Adhesive P/N 08640 or 08641 available locally or Dominion Sure Seal Epoxo 89 P/N XE89 available through:

Dominion Sure Seal, 5496 Gorvan Drive, MISSISSAUGA, ONTARIO L4W 3E6 PHONE: 416-625-7900

along inner surface between glass and sash channel. Refer to Fig. 1.

IMPORTANT: The adhesive must flow between the glass and sash channel for proper repair.

4. Raise glass and allow the adhesive to cure for two hours before lowering glass.

Use the most applicable Labour Operation and time from the Canadian Labour Time Guide.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.